28
PARAMETER
(Soft Key Text)
DESCRIPTION
AVAILABLE
CHOICES
Device (Device)
for COM1
Selects the device connected to the COM1 serial port. The
default setting is LP2742. DotPrt should be selected for a dot
matrix serial printer. BarPrt should be selected for bar code
printing.
DotPrt
MP20
TDP5
ET-LTP
Device (Device)
for COM2
Selects the device connected to the COM2 serial port. The
default setting is Scanner. Scanner should be selected for a
Symbol LS2401 or compatible bar code scanner. PC should be
selected for a full duplex connection to a PC or remote display.
See Appendix B for serial data format.
Scanner
PC
QWERTY
keyboard
TCS
Baud Rate (Baud) Selects the baud rate for data transmission through the serial
port. The default setting for both ports is 9600.
600
1200 2400
4800 9600
Data Bits and
Parity (Bits)
Selects the number of data bits and parity of serial transmission.
The default setting is 8 None.
"8 None" = 8 data bits with no parity bit and 1 stop bit
"7 Odd" = 7 data bits with odd parity bit and 1 stop bit
"7 Even" = 7 data bits with even parity bit and 1 stop bit
8 None
7 Odd
7 Even
Mode of Serial
Transmission
(Mode) for COM2
Selects when data will be sent out of the COM2 serial port to a
computer or remote display. The default setting is Demand.
"Contiu" = Continuous mode; send data continuously
"Demand" = Demand mode; send data when a PRINT command
is issued from the computer.
Contiu
Demand
TABLE 5-6: Com port Sub-menu Items
5.4.8 RESTORE SYSTEM DEFAULTS SUB-MENU (SysDft)
The Restore System Defaults sub-menu allows you completely restore all configuration
settings throughout the scale to those programmed at the factory. This procedure will not
overwrite your item ID storage.
Use with extreme caution – this process cannot be undone!
To access the Restore System Defaults sub-menu, follow the instructions below.
1. From the service menu, press the SYSDEF soft Key
2. Scale prompts “Restore Factory Defaults?”
3. Press the Yes soft key to restore factory settings or press the No soft key to exit.
4. Press the CLR key twice to return to normal operating mode.
5.4.9 LIGHT
1. From the service menu, press the LIGHT soft Key
2. Scale prompts “Setup BKLight”
3. Select either the ON soft key for always on or the Consva soft key where the back light
turns off
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels