Salter-brecknell Weigh Beams Manuel d'utilisateur télécharger pdf

Weigh Beam_setup.doc

Effective: 1-15-04

1000 Armstrong Drive. Fairmont, Minnesota 56031 Tel: 507-238-8702 Fax: 507-238-8271 e-mail:

sales@salterbrecknell.com

Prices FOB Factory, unless otherwise noted. Prices subject to change without notice.

WEIGH BEAM SET-UP

1. Take weigh beams on pallet to an area where it will be used.

2. Unpack weigh beams and place it on the floor.

NOTE: THE LEVELING FEET ARE TURNED ALL THE WAY INTO THE

SCALE TO PREVENT DAMAGE DURING SHIPPING. IT IS IMPORTANT

YOU SCREW THE FEET OUT AN EQUAL NUMBER OF TURNS BEFORE

USE.

3. Use the feet to level the weigh beams.

4. Unpack cable from weigh beams.

5. Connect cable to indicator by connector.

6. Plug AC adapter in to indicator then to power outlet. Make sure that AC voltage

appearing at the wall outlet match the input voltage marked on the AC adapter.

7. Turn indicator on. The indicator will count down then indicate zero weight. If it does

not, then press the ZERO key.

8. If using a platform with the weigh beams place it across the weigh beams then press

the TARE key.

You are now ready to use the weigh beams. If you see any error message or the scale does

not function properly, call 1-800–458-7062 for assistance.

Weigh Beam_setup.docEffective: 1-15-041000 Armstrong Drive. Fairmont, Minnesota 56031 Tel: 507-238-8702 Fax: 507-238-8271 e-mail: sales@salterbr

Pas de commentaire

Salter-brecknell Weigh Beams Manuel d'utilisateur